Manual de uso Candy CH64CCB/S Placa

¿Necesita un manual para su Candy CH64CCB/S Placa? A continuación puedes ver y descargar el manual en PDF gratis en español. Este producto actualmente tiene 3 preguntas frecuentes, 0 comentarios y tiene 0 votos. Si este no es el manual que desea, , contáctenos.

¿Su producto tiene algún defecto y el manual no ofrece ninguna solución? Vaya a Repair Café para solicitar un servicio de reparación gratuito.

Manual de uso

Loading…

Leave a distance of at least 55 mm between the hob and the back wall
and of at least 150 mm between the hob and the vertical furniture or
walls in the lateral side. If a furniture is installed above the hob, the
minimum distance required is 700 mm.
(see Figure 3)
If the bottom part of the hob is adjacent to an area normally accessible
for handling or cleaning operations, a separator it must be put 20 mm
below the bottom part of the hob. (see Figure 4)
When installing a hood above the hob, please consult the installation
requirements specified for the hood but, in any case, the distance
between the hob and the hood must not be lower than 700 mm.
When installing an oven under the hob, separator must not be put and
the minimum distance between the bottom part of the hob and the
oven must not be lower than 10 mm. Do not install not cooled oven
under this hob and install the oven following its own installation
requirements. (see Figure 5)
PRODUCT CODE T
Identification Plate (located under the hob's bottom casing)
1. PROTECTION OF THE ENVIRONMENT
This appliance is marked according to European
Directive 2012/19/EU on Waste Electrical and
Electronic Equipment (WEEE).
WEEE contains both polluting substances (which
can cause negative consequences for the
environment) and basic components which can be
reused.It is important to have WEEE subjected to
specific treatments, in order to remove and dispose
properly all pollutants and recover and recycle all
materials.
WEEE shall not be threatened as household waste.
WEEE shall be handled over to the relevant collection points
managed by the municipality or by registered companies. In many
Countries, for large WEEE, home collection could be present.
Individuals can play an important role in ensuring that the WEEE
does not become an environmental issue; it is essential to follow
some basic rules:
• In many Countries, when you buy a new appliance, the old one
may be returned to the retailer who has to collect it free of charge on
a one-to-one basis, as long as the appliance is of equivalent
typology and has the same functions as the supplied one.
2. INSTALLATION
Installing a domestic appliance it is a complicated operation which, if
not carried out correctly, can seriously have impact on safety of goods,
properties or people. or this reason, it should be carried out by a
professionally qualified person in accordance with technical
regulations.
In the event that this advice it is ignored and installation is carried out
by an unqualified person, the Manufacturer declines all responsibility
for any technical failure of the appliance whether or not it results in
damage of goods or properties or in inury of people or animals.
In addition, all decorative laminates should be fixed with high-resistance
glue.
After having removed the packaging please be sure that the appliance
it is not damaged, otherwise contact the Retailer or Manufacturer After
Sales Service.
Appliance can be installed in a Built-in furniture in Standard (see igure
) or lush(see Figure 2) mode.
Make sure that the furniture in which the appliance will be fitted and all
other furniture in the nearby are made with materials which can
withstand high temperatures (min  C).
Worktop thickness should be between 25 and 45 mm.
- Turn the clips and tighten them fully. (see Figure 8)
A watertight seal gasket is supplied with the hob. Fit the seal gasket
around the bottom hob as described and make sure that it is properly
fitted to avoid any leakage into the supporting furniture. (see Figure 6)
Normal Fixing:
- Get the fixing clips from accessory bag and screw them into the
position shown on bottom box. (Do not tighten the screws to block
clips, they should move freely) (see Figure 7)
- Insert the hob in center position of cut out.
Press the sides of hob until it is supported around its entire perimeter.
(see Figure 10)
FLUSH INSTALLATION
After checking that the position of the hob is correct fill the gap
between the worktop and the hob with silicone adhesive. Flatten the
silicone layer with a scraper or with wet finger damped with water and
soap before it forms.
supported around its entire perimeter. (see Figure 11)
Get four springs form accesory bag and screw them onto bottom box
as shown in figure. (see Figure 9)
Center and insert the hob.
Quick Fixing: (Depending on model)
Do not use the hob until the silicone layer it is completely dry.
05 GB
Note: er erieer iesis re se i sr isi
3. ELECTRICAL CONNECTION
A
B
C D
A
B
C
A
C
B
C
A B
D
A
B
C
D
LAYOUT 1-3 LAYOUT 2-4
LAOUT 1-3
LAOUT 2-
1
2
5
5
7
3
5
5
6
6
6
6
6
6
5
5
3
1
2
4
5
5
6
6
1
2
3
6
6
6
4
5
5
5
6
6
5
5
3
1
2
5
5
6
6
1
2
3
6
6
6
5
5
5
1-3
2-
5
6
7
LAOUT
Descargue el manual en Español (PDF, 12.77 MB)
(Piense en el medioambiente y solo imprima este manual si es de verdad necesario)

Loading…

Puntuación

Dé su opinión de la Candy CH64CCB/S Placa calificando el producto. ¿Quiere compartir su experiencia con este producto o hacer una pregunta? Deje un comentario en la parte inferior de la página.
¿Estás satisfecho con elCandy CH64CCB/S Placa?
No
Sea el primero en calificar este producto
0 votos

Únase a la conversación sobre este producto

Aquí puedes compartir lo que piensas sobre Candy CH64CCB/S Placa. Si tiene alguna pregunta, primero lea atentamente el manual. Puede solicitar un manual utilizando nuestro formulario de contacto.

Más sobre este manual

Entendemos que es bueno tener un manual en papel para tus Candy CH64CCB/S Placa. Siempre puedes descargar el manual desde nuestro sitio web e imprimirlo tú mismo. Si deseas tener un manual original te recomendamos contactar con Candy. Es posible que puedan proporcionar un manual original. ¿Estás buscando el manual de tu Candy CH64CCB/S Placa en otro idioma? Elija su idioma preferido en nuestra página de inicio y busque el número de modelo para ver si lo tenemos disponible.

Especificaciones

Marca Candy
Modelo CH64CCB/S
Categoría Placas
Tipo de archivo PDF
Tamaño del archivo 12.77 MB

Todos los manuales para Candy Placas
Más manuales de Placas

Preguntas frecuentes sobre Candy CH64CCB/S Placa

Nuestro equipo de atención al cliente busca información útil sobre los productos y responde a las preguntas frecuentes. Si encuentra inexactitudes en las preguntas frecuentes, indíquenoslo usando nuestro formulario de contacto.

¿Qué sartenes se pueden usar en una placa de inducción? Verificado

Por lo general, todas las sartenes ferromagnéticas se pueden usar en una placa de inducción. Casi todas las sartenes modernas son aptas para inducción.

Ha sido de gran ayuda (1380) Leer más

El enchufe de mi placa eléctrica no encaja en una toma corriente. ¿Qué debo hacer? Verificado

Muchas placas eléctricas (tanto de cerámica como de inducción) están equipadas con un enchufe diferente. Se debe a que estos aparatos necesitan mucha potencia. Acuda a un profesional para que le instale el aparato.

Ha sido de gran ayuda (1307) Leer más

¿Por qué se escucha un clic al encender el cocina? Verificado

Si se ha limpiado el cocina con abundante agua, los mandos podrían haberse mojado, provocando el encendido. Espere a que los mandos se sequen. Si el problema persiste, contacte con el fabricante.

Ha sido de gran ayuda (1117) Leer más
Manual de uso Candy CH64CCB/S Placa

Productos relacionados

Categorias relacionadas