Manual de uso GE PXCP33SSSW Dispensador de agua

Manual de uso

7

1. Before cleaning, set both power switches

(on the back of the dispenser, if equipped)

in the

O (off)

position and

unplug the water

dispenser

.

NOTE:

For first time installation, skip

steps 2–4.

2. Empty the water bottle, then remove it from

the dispenser.

3. Drain the water tanks (see

Draining the Dispenser

).

4.

Reinstall the silicon stopper and drain cap

(see

Draining the Dispenser

).

5.

DO NOT ADD BLEACH FIRST OR DIRECTLY TO THE

DISPENSER. Concentrated bleach may damage plastic.

Add 1/2 teaspoon (2.5 ml) of ordinary 6.0% maximum

household bleach to a 2 quart (2 liter) pitcher filled

with tap water.

6. Pour the solution in the opening at the top of

the dispenser.

7. Repeat steps 5 and 6 until the dispenser is full.

8. Press the hot and cold dispenser buttons until

the water just begins to flow from the taps.

9. Allow to sit for 15–20 minutes.

10.

Rinse out the bleach solution:

— Drain the water tanks into a large bucket

(see

Draining the Dispenser

).

— Make sure that the silicon stopper is

NOT

installed.

—

IMPORTANT: Remove the separator and wipe out the

cold water reservoir

(see

Cleaning the Separator

).

— Clean, then reinstall the separator and collar

(see

Cleaning the Separator

).

— Pour approximately 1 gallon (4 quarts or 4 liters)

of fresh tap water into the top and allow to drain

into the bucket.

— Flush with an additional 1 gallon (4 quarts or

4 liters) of fresh tap water and allow to drain

into the bucket.

11.

Reinstall the silicon stopper and drain cap

(see

Draining the Dispenser

).

12. Install a fresh water bottle (see

Loading the Dispenser

).

13.

Dispense 1 quart (1 liter) of water from each tap

and taste

to make sure the bleach solution is completely

removed.

If you continue to taste the chlorine from the bleach solution,

repeat steps 10–13 until the taste is gone.

14. Plug in the dispenser. Then turn on the hot

and cold power switches (on the back of the

dispenser, if equipped).

Sanitizing and Cleaning the Water Tanks

IMPORTANT: Set both power switches

(on the back of the dispenser, if equipped)

in the O (off) position and unplug the water

dispenser before cleaning.

1. Remove the water bottle and drain the

dispenser (see

Draining the Dispenser

).

2.

Remove the support collar by turning

counterclockwise and pulling straight off.

3. Remove the plastic separator by pulling

straight out (you may need

to twist slightly to loosen).

4. Clean the separator with dish soap

and water or in the top rack of

the dishwasher.

5. Dry the separator thoroughly on

both sides.

6. Using a clean cloth or paper towel,

thoroughly dry the cold water reservoir.

7. Place the separator back in the

dispenser. Make sure the long, tapered

end of the separator is positioned firmly

on the metal plug on the bottom of the

reservoir.

8. Replace the support collar and turn

clockwise until it is firmly in place.

9. Install a full water bottle on the

dispenser (see

Loading the Dispenser

).

Cleaning the Separator

Separator

Support collar

To remove

To replace

IMPORTANT: Periodically the water dispenser tanks must be sanitized to prevent unpleasant tastes in the water and cleaned to

remove mineral deposits that can impair flow.

To Remove Mineral Deposits:

Mix 2 quarts (2 liters) of water with two quarts of vinegar OR mix 1 gallon of water (4 liters) with 16 ounces (454 g) of citric acid

crystals. Bleach does not remove mineral deposits. Do this in place of step 5 when removing mineral deposits.

To Sanitize:

OFF

position

ON

position

Puntuación

Más sobre este manual

Entendemos que es bueno tener un manual en papel para tus GE PXCP33SSSW Dispensador de agua. Siempre puedes descargar el manual desde nuestro sitio web e imprimirlo tú mismo. Si deseas tener un manual original te recomendamos contactar con GE. Es posible que puedan proporcionar un manual original. ¿Estás buscando el manual de tu GE PXCP33SSSW Dispensador de agua en otro idioma? Elija su idioma preferido en nuestra página de inicio y busque el número de modelo para ver si lo tenemos disponible.

Especificaciones

Todos los manuales para GE Dispensadores de agua
Más manuales de Dispensadores de agua

Preguntas frecuentes sobre GE PXCP33SSSW Dispensador de agua

Nuestro equipo de atención al cliente busca información útil sobre los productos y responde a las preguntas frecuentes. Si encuentra inexactitudes en las preguntas frecuentes, indíquenoslo usando nuestro formulario de contacto.

Productos relacionados

Manual de uso

GE GXCFS7W Dispensador de agua

Manual de uso

GE GXCF25FBS Dispensador de agua

Manual de uso

GE PXCR33KSSW Dispensador de agua

Manual de uso

Tomado TWD2501B Dispensador de agua

Manual de uso

Elkay EZS8WSSK Dispensador de agua

Manual de uso

Orbegozo DA 5650 Dispensador de agua

Manual de uso

Thulos TH-DL07 Dispensador de agua

Manual de uso

Primo 601087-C Dispensador de agua

Categorias relacionadas