Manual de uso Gorenje WHT951S1XBG Campana extractora

Manual de uso

22 EN

After performing the maintenance, with the hood off and the button active, press the button for more than 3 seconds to perform the

reset of the lter saturation indicator; repeat the operation if necessary (for ex., when both lters are saturated).

Activationofthecharcoalltersaturationindicator

The saturation indicator of the charcoal lter is normally disabled. To activate it, proceed in the following manner:

With the display on (ON) and the suction off (OFF), press simultaneously the buttons T8 and T9 for more than 3 seconds; the button

T9 lights on with steady light for approx. 5 seconds, to indicate the activation.

To disable it, repeat the operation; the button T9 will ash for approx. 5 seconds to indicate the disabling.

Buttons T8 and T9 are not visible at this stage (on some models). They are visible only as described

in operation section of the manual.

Approximate distance of button T8 from T7 is 15 mm, and distance of button T9 from T8 is 40 mm.

Setting of Automatic Operation parameters

For correct use of the automatic operation, perform „Hood Calibration”.

Hood Calibration

With the display on (ON) and the suction off (OFF), press button T3 for 3 seconds.

The suction speed (power) 2 starts functioning and button T3 ashes to indicate that hood calibration is initiated and it will last for approx.

15 minutes.

Note: to interrupt the calibration, press T3 for 5 seconds; the calibration will be invalidated and should therefore be repeated.

WHT943A2XBG, WHT643A2XBG, WHT663S2X, WHT963S2X

To select the functions of the hood press on the symbol. Function will be activated when symbol will be released.

T1. Standby mode (the control panel off – all functions disabled) / ON (control panel switched on)

Note: After about a minute of inactivity (suction and lights), the hood will automatically switch to standby.

T2. ON/OFF lights

On certain models only (see drawing above):

press repeatedly to select the desired light intensity:

L1: low light

L2: medium light

L3: high light

Press again to turn off the lights.

T3. ON/OFF Automatic operation “AdaptTech”.

The hood automatically sets the suction speed (power) 1 to increase if the environmental conditions detected by the hood sensor

require it.

If there are no variations in the environmental conditions, after 10 minutes (if the hood is already in suction speed (power) 1), the hood

turns off.

Note: for a correct use of this function, rst perform the „Setting of the parameters for Automatic Operation” (see corresponding

paragraph).

Note: During automatic operation, if the user acts on the other functions that adjust the speed, auto ventilation function is switched off.

T4. Manual selection of the suction speed (power):

L4: suction speed (power) 1

L5: suction speed (power) 2

L6: suction speed (power) 3

Press again to turn off the hood (OFF).

Note: manual selection excludes any other suction related set function.

T5. ON/OFF Intensive suction speed (power) “POWER BOOST” (timed)

Note: After 5 minutes of operation the hood returns to its previous state.

T6*. (Only certain models ON/OFF intensive suction speed (power) “POWER BOOST x 2” (timed)

Note: After 5 minutes of operation, the hood goes back to the previous status.

T7. ON/OFF operation mode „ReFresh”.

Every 50 minutes of inactivity, the suction speed (power 1 is turned on for 10 minutes.

T8. ON/OFF Timer of the suction speed (power) (approx. 30 minutes)

Note: this function is available for the speeds that can be selected with button T4.

T9. Indicatorandresetltersaturation

The button lights on automatically with steady light when it is necessary to perform the grease lter maintenance.

The button lights on automatically with ashing light when it is necessary to perform the charcoal lter maintenance.

After performing the maintenance, with the hood off and the button active, press the button for more than 3 seconds to perform the

T1 T2 T3 T4 T5 T6 T7 T8 T9

L1 L2 L3 L4 L5 L6

T7 T8 T9

15 mm 40 mm

Puntuación

Más sobre este manual

Entendemos que es bueno tener un manual en papel para tus Gorenje WHT951S1XBG Campana extractora. Siempre puedes descargar el manual desde nuestro sitio web e imprimirlo tú mismo. Si deseas tener un manual original te recomendamos contactar con Gorenje. Es posible que puedan proporcionar un manual original. ¿Estás buscando el manual de tu Gorenje WHT951S1XBG Campana extractora en otro idioma? Elija su idioma preferido en nuestra página de inicio y busque el número de modelo para ver si lo tenemos disponible.

Especificaciones

Todos los manuales para Gorenje Campanas extractoras
Más manuales de Campanas extractoras

Preguntas frecuentes sobre Gorenje WHT951S1XBG Campana extractora

Nuestro equipo de atención al cliente busca información útil sobre los productos y responde a las preguntas frecuentes. Si encuentra inexactitudes en las preguntas frecuentes, indíquenoslo usando nuestro formulario de contacto.

Productos relacionados

Manual de uso

Gorenje WHI643FORAW Campana extractora

Manual de uso

Gorenje WHT621E3XBG Campana extractora

Manual de uso

Gorenje WHT941A2XBG Campana extractora

Manual de uso

Gorenje DT9545AX/UK Campana extractora

Manual de uso

Gorenje IHT953S2XBG Campana extractora

Manual de uso

Gorenje WHI961S2X Campana extractora

Manual de uso

Gorenje BHP603E9X Campana extractora

Manual de uso

Gorenje WHT961S2X Campana extractora

Categorias relacionadas