Manual de uso Hansgrohe Metris Grifería

¿Necesita un manual para su Hansgrohe Metris Grifería? A continuación puedes ver y descargar el manual en PDF gratis en español. Este producto actualmente tiene 1 pregunta frecuente, 1 comentario y tiene 0 votos. Si este no es el manual que desea, , contáctenos.

¿Su producto tiene algún defecto y el manual no ofrece ninguna solución? Vaya a Repair Café para solicitar un servicio de reparación gratuito.

Manual de uso

Loading…

2
English
Technical Information
Water pressure
Recommended 15 - 75 PSI (0.1 - 0.5 MPa)
Maximum 145 PSI (1 MPa)
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum 158°F (70° C)*
Max. flow rate 0.5 GPM (1.9 L/min)
0.08 gallons (0.3 liter) per cycle**
Hole size in mounting surface 1⅜" (35 mm)
Max. depth of mounting surface 1⅝" (40 mm)
Battery CR-P2 / 6 V Lithium
Automatic shutoff after 10 seconds***
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
** 10 second maximum cycle time
*** This is the maximum amount of time the faucet will run
while a hand is within range of the sensor.
Installation Considerations
For best results, Hansgrohe recommends that this unit be
installed by a licensed, professional plumber.
Please read over these instructions thoroughly before
beginning installation. Make sure that you have all tools
and supplies needed to complete the installation.
Keep this booklet and the receipt (or other proof of date
and place of purchase) for this product in a safe place.
The receipt is required should it be necessary to request
warranty parts.
Flush the hot and cold supplies thoroughly before installing
the faucet. Damage to the faucet caused by debris is not
covered under the warranty.
The hot and cold supplies should be of equal pressure.
The faucet should not be used with a continuous flow water
heater.
Do not install the faucet on a sink with a raised edge.
Strong light sources should not shine directly on the sensor
window of the faucet.
The faucet should only be used with the battery pack
supplied by Hansgrohe. Do not attempt to use any other
battery pack.
The faucet incorporates automatic range adjustment --
the sensor automatically adjusts itself to local conditions
(lavatory, brightness, etc.)
The distance between the switch on/off point to the faucet
is approx. 6¼" - 8" under normal conditions. The detection
area may be less for dark, non-reflective objects, or greater
for bright, highly reflective objects.
If the sink is very small or highly reflective,
follow the range reduction instructions. When
the faucet is in reduced range mode, the LED in the
sensor window will flash while the faucet is not in use.
Drops of water or condensation on the sensor window
may cause the faucet to run.
The spray pattern will be unattractive
immediately after installation or service, due
to air in the faucet. After the faucet is used 10
- 15 times, the spray pattern will clear.
At the start of operation, or after maintenance, function
of the faucet may be delayed due to reflections during
adjustment of the operating distance. The faucet will
automatically calibrate itself. The self-calibration will start
after 10-15 minutes.
Hansgrohe recommends not to use as drinking water
the first half liter (approximately 1 pint) flowing from
the faucet in the morning, or after prolonged non-use.
Descargue el manual en Español (PDF, 5.67 MB)
(Piense en el medioambiente y solo imprima este manual si es de verdad necesario)

Loading…

Puntuación

Dé su opinión de la Hansgrohe Metris Grifería calificando el producto. ¿Quiere compartir su experiencia con este producto o hacer una pregunta? Deje un comentario en la parte inferior de la página.
¿Estás satisfecho con elHansgrohe Metris Grifería?
No
Sea el primero en calificar este producto
0 votos

Únase a la conversación sobre este producto

Aquí puedes compartir lo que piensas sobre Hansgrohe Metris Grifería. Si tiene alguna pregunta, primero lea atentamente el manual. Puede solicitar un manual utilizando nuestro formulario de contacto.

Fernand Vanden Hoeck 23-07-2025
Todavía hay un manual de lenguaje holandés disponible para el Metris S Chrome Pix 9950/IA No sace las Flexibels de la toque

responder | Ha sido de gran ayuda (0) (Traducido por Google)

Más sobre este manual

Entendemos que es bueno tener un manual en papel para tus Hansgrohe Metris Grifería. Siempre puedes descargar el manual desde nuestro sitio web e imprimirlo tú mismo. Si deseas tener un manual original te recomendamos contactar con Hansgrohe. Es posible que puedan proporcionar un manual original. ¿Estás buscando el manual de tu Hansgrohe Metris Grifería en otro idioma? Elija su idioma preferido en nuestra página de inicio y busque el número de modelo para ver si lo tenemos disponible.

Especificaciones

Marca Hansgrohe
Modelo Metris
Categoría Griferías
Tipo de archivo PDF
Tamaño del archivo 5.67 MB

Todos los manuales para Hansgrohe Griferías
Más manuales de Griferías

Preguntas frecuentes sobre Hansgrohe Metris Grifería

Nuestro equipo de atención al cliente busca información útil sobre los productos y responde a las preguntas frecuentes. Si encuentra inexactitudes en las preguntas frecuentes, indíquenoslo usando nuestro formulario de contacto.

El agua del grifo solo se pone tibia. ¿Qué puedo hacer? Verificado

Asumiendo que no hay ningún problema con el suministro de agua caliente podría que haya acumulaciones de minerales en el grifo. Esto puede obstruir la regulación de la temperatura. También es posible que el mecanismo dentro del grifo se haya roto. En tal caso probablemente tendrá que ser reemplazado.

Ha sido de gran ayuda (513) Leer más
Manual de uso Hansgrohe Metris Grifería

Productos relacionados

Categorias relacionadas

×
Download