Manual de uso Primo 601258 Dispensador de agua

¿Necesita un manual para su Primo 601258 Dispensador de agua? A continuación puedes ver y descargar el manual en PDF gratis en español. Este producto actualmente tiene 0 preguntas frecuentes, 0 comentarios y tiene 0 votos. Si este no es el manual que desea, , contáctenos.

¿Su producto tiene algún defecto y el manual no ofrece ninguna solución? Vaya a Repair Café para solicitar un servicio de reparación gratuito.

Manual de uso

Loading…

1. Place the dispenser on the floor in the desired location
in your home. Product is intended for indoor use only.
[Note: Do NOT plug power cord into wall outlet until
instructed.]
2. Position dispenser so the back is at least 4 inches
from wall and there are at least 4 inches of clearance
on both sides.
3. Slide drip tray into place.
4. Slide brewer cup drawer into the slot until it clicks.
CAUTION: Keep fingers away from the inside of the
tray as the needle is very sharp.
5. Clean probe with a damp cloth and
dish soap. (Visit PrimoWater.com for
detailed cleaning instructions.)
Place probe assembly on hanger
inside door to keep it clean.
6. Grab a bottle of Primo
®
water (sold separately) and
fully remove the cap. Insert probe assembly into bottle.
Press firmly to secure assembly over bottle opening.
For 3-gallon bottles, squeeze the tabs on the top of
the probe assembly to separate the probe cap from
the collar and press the collar securely over the
bottle opening.
7. Slide bottle inside the cabinet and close cabinet door.
[Note: Water will not pump from bottle unless door is
fully closed.]
8. Plug dispenser into a ground fault circuit
interrupting (GFCI) outlet. You will hear the
dispenser begin to pump water to fill the
internal hot and cold reservoirs.
9. Turn on desired functions by flipping the switches on
the back of the dispenser to the ON position.
Blue – nightlight
Green – chills water
Red – heats water
10. Once the dispenser has stopped filling
the internal reservoirs, dispense and
dispose at least 1 quart (approximately
2 pint glasses) of water from both the
hot and cold spouts.
11. Your water will be ready to dispense fully chilled in
approximately 1 hour or piping – hot in approximately
12 minutes.
12. Register your dispenser at PrimoWater.com to
activate your warranty, which runs for 1 year from
date of purchase.
Inside of door
Press to Unlock
®
®
5 Gallon 3 Gallon
®
1
QT
1
HR
12MIN
FEATURES
STORAGE COMPARTMENT – Removable tray keeps
single-serve brewer pods organized. (Pods sold separately.)
CONVENIENCE SWITCHESOn/off switches for
heating, cooling and nightlight are located on the back
of the dispenser.
BREW CONTROLS for single-serve beverage dispensing –
Select 6, 8 or 10 ounce serving size.
EMPTY BOTTLE LIGHT – Blinks red when the bottle is
empty and needs to be replaced.
HEATING LIGHT – Flashes when the water is heating. Stops
flashing when water is fully heated.
BREWER CUP DRAWER – Brews single-serve beverage
pods. Press gray button to remove drawer. CAUTION: Keep
fingers clear of sharp needle inside drawer.
COLD WATER PADDLE CONTROL – Press drinking
glass or container against the paddle to dispense.
Release to stop.
HOT WATER PADDLE CONTROL with child-resistant
safety feature – Push red button and press mug or container
against the paddle to dispense. Release to stop.
PROBE ASSEMBLY – Probe pumps water from the bottle
into the hot and cold reservoirs.
PROBE HANGER – Rest probe assembly on the hanger
(located inside the cabinet door) to keep it clean while
replacing bottles.
DRIP TRAY with Full Indicator – Removable and
dishwasher-safe. Red indicator rises when it’s time to empty.
WATER BOTTLE – Not included. Uses 3 and 5-gallon
bottles. Visit PrimoWater.com to find Primo
®
water at the
store nearest you.
WARNINGS & SAFETY PRECAUTIONS
To reduce risk of injury and property damage, user must read this entire guide
before assembling, installing & operating dispenser.
Failure to execute the instructions in this manual can cause personal injury or
property damage. Models that heat water dispense at very high temperatures.
Failure to use properly can cause personal injury.
When operating this dispenser, always exercise basic safety precautions, including
the following:
Prior to use, this dispenser must be properly assembled and installed
in accordance with this manual.
This dispenser is intended for water dispensing only. Do NOT use other
liquids. Do NOT use for other purposes. Never use any liquid in the dispenser
other than known and microbiologically safe bottled water.
For indoor use only. Keep water dispenser in a dry place away from
direct sunlight. Do NOT use outdoors.
Install and use only on a hard, flat and level surface.
Do NOT place dispenser into an enclosed space or cabinet.
Do NOT operate dispenser in the presence of explosive fumes.
Position back of dispenser no closer than 4 inches from wall and
permit free airflow between wall and dispenser. There must be at least
4 inches clearance on the sides of the dispenser to permit airflow.
The dispenser is intended to be plugged into a ground fault interrupting
receptacle.
Do not use an extension cord with your water dispenser.
Always grasp plug and pull straight out from outlet. Never unplug by
pulling on power cord.
Do NOT use dispenser if cord becomes frayed or otherwise damaged.
To protect against electric shock, do NOT immerse cord, plug, or any
other part of dispenser in water or other liquids.
Ensure dispenser is unplugged prior to cleaning.
Never allow children to dispense hot water without proper and direct
supervision. Unplug unit to prevent unsupervised use by children.
Do not dispense hot water if water bottle is empty.
Please contact us at 866-429-7566 for troubleshooting assistance.
1 2 3 4
QUICK START GUIDE
Available at thousands of locations nationwide. Learn more at
PrimoWater.com/locations.
Primo® Pre-Filled Exchange Water or Self-Service Refill
Water from Primo® & Glacier® (sold separately)
#601258 B380K
Descargue el manual en Español (PDF, 1.04 MB)
(Piense en el medioambiente y solo imprima este manual si es de verdad necesario)

Loading…

Puntuación

Dé su opinión de la Primo 601258 Dispensador de agua calificando el producto. ¿Quiere compartir su experiencia con este producto o hacer una pregunta? Deje un comentario en la parte inferior de la página.
¿Estás satisfecho con elPrimo 601258 Dispensador de agua?
No
Sea el primero en calificar este producto
0 votos

Únase a la conversación sobre este producto

Aquí puedes compartir lo que piensas sobre Primo 601258 Dispensador de agua. Si tiene alguna pregunta, primero lea atentamente el manual. Puede solicitar un manual utilizando nuestro formulario de contacto.

Más sobre este manual

Entendemos que es bueno tener un manual en papel para tus Primo 601258 Dispensador de agua. Siempre puedes descargar el manual desde nuestro sitio web e imprimirlo tú mismo. Si deseas tener un manual original te recomendamos contactar con Primo. Es posible que puedan proporcionar un manual original. ¿Estás buscando el manual de tu Primo 601258 Dispensador de agua en otro idioma? Elija su idioma preferido en nuestra página de inicio y busque el número de modelo para ver si lo tenemos disponible.

Especificaciones

Marca Primo
Modelo 601258
Categoría Dispensadores de agua
Tipo de archivo PDF
Tamaño del archivo 1.04 MB

Todos los manuales para Primo Dispensadores de agua
Más manuales de Dispensadores de agua

Manual de uso Primo 601258 Dispensador de agua

Productos relacionados

Categorias relacionadas