u Never touch the cutting line while the appliance is running.
u Do not put the appliance down until the cutting line has
come to a complete standstill.
u Use only the appropriate type of cutting line.
Never use metal cutting line or shing line.
u Be careful not to touch the line trimming blade.
u Take care to keep the mains cable away from the cutting
line. Always be aware of the position of the cable.
u Keep hands and feet away from the cutting line at all
times, especially when switching on the motor.
u Before using the appliance and after any impact, check for
signs of wear or damage and repair as necessary.
u Never operate the appliance with damaged guards or
without guards in place.
u Take care against injury from any device tted for trimming
the lament line length. After extending new cutter line
always return the machine to its normal operating position
before switching on.
u Always ensure that the ventilation slots are kept clear of
debris.
u Do not use the lawn trimmer (edge trimmer), if the cords
are damaged or worn.
u Keep extension cords away from cutting elements.
Labels on appliance
The following warning symbols are found on the appliance:
+
Read the manual prior to operation.
F
Wear safety glasses or goggles when operating this
appliance.
8
Keep people and animals at least 6 m away from the
cutting area.
R
Do not expose the appliance to rain or high humidity.
Electrical safety
#
This appliance is double insulated; therefore no earth
wire is required. Always check that the power supply
corresponds to the voltage on the rating plate.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Trigger lever (on/off switch)
2. Handle
3. Cable restraint
4. Power inlet
5. Secondary handle
6. Adjustment button
7. Cable storage hooks
8. Motor housing
9. Guard
10. Line trimming blade
11. Spool housing
12. Cutting line
13. Edge guide
14. Tube
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fittingtheguard(g.A)
u Remove the screw (15) from the guard (9).
u Place the guard onto the tool as shown.
u Firmly press the guard until it snaps into place.
u Secure the guard with the screw.
Warning! Never use the tool unless the guard is properly tted.
Connectingthetooltothemains(g.B)
u Connect the female plug of a suitable extension cable to
the power inlet (4).
u Loop the cable through the cable restraint (3).
u Insert the mains plug into a mains outlet.
For wired in cable units: Make sure the cable is looped
through the cable restraint prior to connecting the plug to
the mains outlet.
Warning! The extension cable must be suitable for outdoor use.
Settingthetooltotheworkingposition(g.C)
The tool is supplied in a shipping position. The tool must be
set to a working position before use.
u Gently pull out the tube (14) until the adjustment button (6)
locks into place.
u When the button locks into place, the tool is set to the
shortest working position.
Warning! Never use the tool unless it is in a working position.
Fittingtheedgeguide(g.D)
u Position the edge guide (13) in front of the tool as shown.
u Gently pull apart the edge guide legs.
u Slide the legs over the motor housing (8) into the holes
(16) on either side.
u Make sure the edge guide ts properly into the motor
housing guides.
Únase a la conversación sobre este producto
Aquí puedes compartir lo que piensas sobre Black and Decker GL655 Cortabordes. Si tiene alguna pregunta, primero lea atentamente el manual. Puede solicitar un manual utilizando nuestro formulario de contacto.